Slide over, rover. These slithering robots are looking to be the next step for Mars exploration.
So far, the only robots to be sent to the Martian surface have come in the form of stationary landers or mobile rovers. But could the next generation of robotic Mars explorer come in the form of a… snake?
This little bit of lateral, slithery thinking comes from researchers at SINTEF (Stiftelsen for Industriell og Teknisk Forskning), a research institute based in Trondheim, Norway, who have built prototype robotic snakes that could explore where no Mars rover has ever explored before.
The key problem with any robotic Mars exploration effort is that of maneuverability, even the most agile of wheeled rover has limits on what it can do. The best thing about snakes is that they are the ultimate contortionists able to probe any nook and cranny, avoiding hazards along the way.
“Manoeuvrability is a challenge. The Spirit rover was lost after it became stuck in the sand on Mars. The vehicles just cannot get to many of the places from which samples have to be taken”, said SINTEF researchers Pål Liljebäck and Aksel Transeth.
This work is based on a feasibility study funded by the European Space Agency (ESA), which is investigating different ways of exploring and sampling planetary surfaces. The SINTEF study focuses on a snake-like appendage for a more traditional Mars rover.
Like NASA’s Mars Science Laboratory’s robotic arm that is used to get up-close and personal with rocky samples, focusing the attached MAHLI (Mars Hand Lens Imager) camera on small-scale geological features, a snake-like probe could go one better, detaching itself and “slithering” up to samples and collecting them from hard-to-reach locations.
“We are looking at several alternatives to enable a rover and a robot to work together,” said Transeth. “Since the rover has a powerful energy source, it can provide the snake robot with power through a cable extending between the rover and the robot. If the robot had to use its own batteries, it would run out of power and we would lose it.”
“One option is to make the robot into one of the vehicle’s arms, with the ability to disconnect and reconnect itself, so that it can be lowered to the ground, where it can crawl about independently.”
The independent nature of the robotic snake means that it could also come to the aid of its rover “mother ship” should its wheels get stuck in loose regolith. The snake could coil itself around a rock, and via an attached winch, the rover could use the snake as an anchor, pulling itself loose.
Norwegian researchers have worked on snake robot technology for several years and the robotics are beginning to mature.